Post by OptimallyDismal on Jun 8, 2022 21:36:23 GMT -6
Took the load sense control off the 846 today, not much to the unit, bugger to get off though.
Thought since I had it out and there is a number on it I would check with the hydraulic repair gurus on whether they had a new one or parts if things go bad.
Guy wants pictures, wasn't sure what it was, this is 4:15, so send pix, while talking to him on the phone, says he will phone back when he has seen the pix, they close at 5.
Phone at 4:50, guy said he was busy so not sure if he would have called back?
Still doesn't know what it is, I said load sense control? OH YA that's what it is!!! He says bring it in so they can check it over for seals springs and check balls.
There are no seals or check balls, so let's just say I am not planning a trip over there. In the winter they wanted me to take the whole pump off and bring it in because there were parts that would fly out if I just took it off, not so, it appears.
One of the spool parts that goes in the spring looked like it had a burr, so cleaned it up a bit, but I think it is hard stuff, so maybe not deformed.
Nothing was stuck, dirty, bent, or looked out of place, so put it back together and back on the tractor, air seeder fan seemed to run OK for a little test, so I guess I will give it a go tomorrow.
I can't believe there are no parts, replacements, or info from any of the businesses I have dealt with, the hydraulic shop and the dealer!
Thought since I had it out and there is a number on it I would check with the hydraulic repair gurus on whether they had a new one or parts if things go bad.
Guy wants pictures, wasn't sure what it was, this is 4:15, so send pix, while talking to him on the phone, says he will phone back when he has seen the pix, they close at 5.
Phone at 4:50, guy said he was busy so not sure if he would have called back?
Still doesn't know what it is, I said load sense control? OH YA that's what it is!!! He says bring it in so they can check it over for seals springs and check balls.
There are no seals or check balls, so let's just say I am not planning a trip over there. In the winter they wanted me to take the whole pump off and bring it in because there were parts that would fly out if I just took it off, not so, it appears.
One of the spool parts that goes in the spring looked like it had a burr, so cleaned it up a bit, but I think it is hard stuff, so maybe not deformed.
Nothing was stuck, dirty, bent, or looked out of place, so put it back together and back on the tractor, air seeder fan seemed to run OK for a little test, so I guess I will give it a go tomorrow.
I can't believe there are no parts, replacements, or info from any of the businesses I have dealt with, the hydraulic shop and the dealer!
